Did you perform the Hydraulic Brake System Diagnostic Check?

--

Go to Step 2

Go to Hydraulic Brake Diagnostic System Check

Inspect the disc brake pads and brake shoe linings for the following conditions:

Refer to Brake Pad Inspection in Disc Brakes or Brake Shoe Inspection in Drum Brakes.

Do any of the above conditions apply?

--

Go to Step 3

Go to Step 4

Replace the brake linings. Refer to the appropriate procedure:

Is the repair complete?

--

Go to Step 8

--

Inspect the brake rotors for the following conditions:

Refer to the following procedures:

Do any of the above conditions apply?

--

Go to Step 5

Go to Step 6

1. Refinish the brake rotor. Refer to Brake Rotor Refinishing in Disc Brakes.
2. Inspect the brake rotor thickness. Refer to Component Specifications in Disc Brakes.
3. If refinishing the brake rotor results in a thickness that is less than the thinnest (Refinishing) thickness, replace the rotor. Refer to Front Brake Rotor Replacement or Rear Brake Rotor Replacement in Disc Brakes.

Is the repair complete?

--

Go to Step 8

--

Inspect the brake assembly for loose, broken, or missing components. Refer to the appropriate procedure:

Are there any loose, broken, or missing brake assembly components?

--

Go to Step 7

Go to Step 8

Tighten or replace the loose, broken or missing brake assembly components. Refer to the appropriate procedure:

Is the repair complete?

--

Go to Step 8

--

Verify proper brake system operation.

Does the brake system operate properly?

--

System OK

Go to Hydraulic Brake Diagnostic System Check