GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Isuzu 🢒 1999 🢒 S/T Isuzu - 4WD 🢒 Body and Accessories 🢒 Body Rear End 🢒 Endgate Lock Striker Replacement

Removal Procedure

    Object Number: 736 Size: SH
  1. Remove the tail lamp. Refer to Tail Lamp Replacement in Lighting Systems.
  2. Perform the following steps in order to remove the pickup box endgate cable from the striker bolt:
    3. 2.1. Open the endgate.
    2.2. Safely support the endgate.
    2.3. Disconnect the slotted hole at the end of the cable from the endgate striker bolt.
  3. Remove the nuts and bolts that retain the pickup box endgate striker to the vehicle.
  4. Remove the pickup box endgate striker from the vehicle.

Installation Procedure

    Object Number: 736 Size: SH
  1. Install the pickup box endgate striker to the vehicle.
  2. Install the nuts that retain the pickup box endgate striker to the vehicle.

    3. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the bolts that retain the pickup box endgate striker to the vehicle.

    4. Tighten
    Tighten the bolts to 25 N·m (18 lb in).

  4. Connect the pickup box endgate cable to the endgate striker bolt.
  5. Install the tail lamp. Refer to Tail Lamp Replacement in Lighting Systems.