Endgate Handle Replacement Pickup

1. Use a flat-bladed tool in order to remove the pickup box endgate latch handle bezel.



2. Perform the following steps in order to remove the endgate latch rods from the endgate latch handle:

2.1.	Separate the retaining clip from the lower latch rod by prying the clip apart at the head of the latch rod.

2.2.	Slide the lower latch rod from the retaining clip and the handle.

2.3.	Lift the endgate latch handle in order to gain access to the upper latch rod retaining clip.

2.4.	Separate the upper latch rod retaining clip from the upper latch rod.

2.5.	Slide the upper latch rod from the retaining clip.




3. Remove the bolts that retain the pickup box endgate latch handle to the endgate.
4. Remove the pickup box endgate latch handle from the endgate.

1. Install the pickup box endgate latch handle to the endgate.




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the bolts that retain the pickup box endgate latch handle to the endgate.

Tighten
Tighten the bolts to 25 N·m (18 lb ft).

3. Install the upper latch rod to the handle.
4. Install the upper latch rod to the retaining clip.
5. Install the lower latch rod to the handle.
6. Install the lower latch rod to the retaining clip.



7. Perform the following steps in order to install the pickup box endgate latch:

7.1.	Position the bezel.

7.2.	Snap the bezel into place.