GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Isuzu 🢒 1999 🢒 S/T Isuzu - 4WD 🢒 General Information 🢒 General Information 🢒 Inner Shaft Seal and Bearing Replacement

Removal Procedure

Tools Required

    • J 23907 Slide Hammer
    • J 29369-1 Universal Bearing Remover
  1. Remove the inner axle shaft. Refer to Inner Axle Housing Shaft and Housing Replacement .
  2. Hold the inner axle shaft housing in a vise by the carrier mounting flange.
  3. Remove the inner axle shaft seal using a suitable seal remover.

    4. Object Number: 9105 Size: SH
  4. Remove the inner axle shaft bearing using the J 29369-1 and the J 23907 .

Installation Procedure

Tools Required

    • J 8092 Driver Handle
    • J 23911 Seal Installer
    • J 42211 Bearing Installer
  1. Place the inner axle shaft housing to carrier flange flat on a level surface.

    2. Object Number: 524680 Size: SH
  2. Install the inner axle shaft bearing using the J 42211 and the J 8092 .

    3. The bearing is installed to the proper depth when the tool is flush with the tube end.

  3. Lubricate the bearing using axle lubricant. Refer to Fluid and Lubricant Recommendations in Maintenance and Lubrication.

    4. Object Number: 321864 Size: SH
  4. Install the inner axle shaft seal with the J 23911 . Drive in the seal until the seal flange is flush with the tube end.
  5. Install the inner axle shaft. Refer to Inner Axle Housing Shaft and Housing Replacement .