The service of the instrument panel cluster (IPC) may consist of replacing the IPC.

Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

1. Disconnect the battery negative cable.
2. Remove the instrument panel accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement .



3. Remove the 4 screws that retain the cluster to the instrument panel.
4. Disconnect the electrical connections, as needed.
5. Remove the cluster from the instrument panel.

1. Install the cluster to the instrument panel. Firmly seat the cluster into the instrument panel.
2. Connect the electrical connections, as needed.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the screws.

Tighten
Tighten the screws that retain the instrument panel cluster to the instrument panel to 1.9 N·m (17 lb in).

4. Install the instrument panel accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement .
5. Connect the battery negative cable.