GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Isuzu 🢒 2000 🢒 S/T Isuzu - 4WD 🢒 Driveline/Axle 🢒 Transfer Case - NVG 233-NP1 (Two Speed Selectable) 🢒 Shield Replacement

Removal Procedure
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.

    2. Object Number: 449294 Size: SH
  2. Remove the nuts securing the transfer case shield to the transfer case.

    3. Object Number: 449298 Size: SH
  3. Remove the nuts securing the transfer case shield to the transfer case.

Installation Procedure

    Object Number: 449294 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  1. Install the nuts securing the transfer case shield to the transfer case.

    2. Tighten
    Tighten the nuts to 35 N·m (26 lb ft).


    Object Number: 449298 Size: SH
  2. Install the nuts securing the transfer case shield to the transfer case.

    3. Tighten
    Tighten the nuts to 35 N·m (26 lb ft).

  3. Lower the vehicle.