For 1990-2009 cars only
Removal Procedure
- Remove the rear propeller shaft. Refer to Rear Propeller Shaft Replacement .
- Remove the center bearingg nuts and bolts.
- Remove the propeller shaft with the center bearing support from the crossmember.
- Remove the shaft from the transmission or transfer case.
Installation Procedure
- Install the propeller shaft with the center bearing support to the transmission (or to the transfer case) and to the crossmember.
- Install the center bearing support bolts to the support bearing.
- Install the nuts with the washers to the support bearing bolts.
- Install the rear propeller shaft. Refer to Rear Propeller Shaft Replacement .
Important: Install both propeller shafts with the universal joints in phase.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the nuts to 70 N·m (50 lb ft).
