Notice: Do not allow the metal coils of the blower resistor to become grounded to any metal surface. This may result in internal circuitry damage.

Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

1. Disconnect the battery negative cable.
2. Remove the blower resistor harness.
3. Remove the stud from the dash panel.



4. Remove the blower motor resistor (1).

1. Install the blower motor resistor (1).
2. Install the stud to the dash panel.
3. Install the resistor harness.
4. Connect the battery negative cable.