GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Isuzu 🢒 2000 🢒 S/T Isuzu - 4WD 🢒 Body and Accessories 🢒 Wiring Systems 🢒 Supplemental Restraint Instrument Panel Module Disable Switch Replacement

Removal Procedure

    Object Number: 602592 Size: SH

    Caution: This vehicle is equipped with a Supplemental Restraint System (SRS). Failure to follow the correct procedure could cause the following conditions:

       • Air bag deployment
       • Personal injury
       • Unnecessary SRS system repairs
    In order to avoid the above conditions, observe the following guidelines:
       • Refer to SRS Component Views in order to determine if you are performing service on or near the SRS components or the SRS wiring.
       • If you are performing service on or near the SRS components or the SRS wiring, disable the SRS system. Refer to Disabling the SRS System in SRS.

  1. Disable the SRS system. Refer to Disabling the SRS .
  2. Remove the trim plate-IP accessory panel.
  3. Release the four locking tabs (1) on the passenger AIR BAG disable switch.

    4. Object Number: 388332 Size: SH
  4. Remove the switch from the instrument panel.
  5. Disconnect the electrical connections, as needed.

Installation Procedure

    Object Number: 388332 Size: SH
  1. Connect the electrical connections, as needed.
  2. Install the switch to the instrument panel by firmly pressing the switch into place.
  3. Enable the SRS system. Refer to Enabling the SRS .