GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Oldsmobile 🢒 2000 🢒 Alero 🢒 Engine 🢒 Engine Cooling 🢒 Accelerator Control Cable Bracket Replacement

Removal Procedure

    Object Number: 294522 Size: SH
  1. Disconnect the accelerator and cruise control cables from the throttle body lever.
  2. Depress the tangs and remove the accelerator and cruise control cables from the accelerator cable bracket.

    3. Object Number: 319387 Size: SH
  3. If applicable disconnect the cruse control cable from the throttle lever and accelerator bracket.

    4. Object Number: 12689 Size: SH
  4. Remove the nuts and bolts holding the accelerator cable bracket to the throttle body.
  5. Remove the accelerator cable bracket.

Installation Procedure

    Object Number: 12689 Size: SH
  1. Install the accelerator cable bracket to the throttle body.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the nuts and bolts.

    3. Tighten

        • Tighten the nuts to 10 N·m (89 lb in).
        • Tighten the bolts to 13 N·m (115 lb in).

    Object Number: 294522 Size: SH
  3. Connect the accelerator cable into the accelerator cable bracket.
  4. Connect the accelerator cable cross slug to the throttle body slots.

    5. Object Number: 319387 Size: SH
  5. If applicable connect the cruse control cable to the throttle lever and accelerator bracket.