GM Service Manual Online
For 1990-2009 cars only

Step

Action

Value(s)

Yes

No

1

Did you review the HVAC operation and perform the necessary inspections?

--

Go to Step 2

Go to Symptoms - HVAC Systems - Manual

2

  1. Turn the ignition switch to the RUN position.
  2. Turn the blower switch to LOW.
  3. Use the J 39200 Digital Multimeter (DMM) in order to backprobe the heater A/C control assembly connector C1.
  4. Measure the voltage between terminal H and ground.

Does the voltage measured equal the specified value?

B+

Go to Step 3

Go to Step 4

3

  1. Disconnect the blower resistor assembly.
  2. Use the J 39200 DMM in order to measure the voltage between terminal B of the blower resistor assembly connector and ground.

Does the voltage measured equal the specified value?

B+

Go to Step 5

Go to Step 6

4

Replace the heater A/C control assembly. Refer to Control Assembly Replacement .

Is the repair complete?

--

System OK

--

5

Replace the blower resistor assembly. Refer to Blower Motor Resistor Replacement .

Is the repair complete?

--

System OK

--

6

Repair the open in CKT 60 between the heater A/C assembly and the blower resistor assembly. Refer to Wiring Repairs in Wiring Systems.

Is the repair complete?

--

System OK

--