Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Was the Wiper/Washer System Check performed? | -- | Go to Step 2 | |
2 |
Do the wipers park properly? | -- | Go to Step 3 | Go to Step 4 |
3 | Replace the wiper/washer switch. Refer to Multifunction Turn Signal Lever Replacement in Steering. Is the replacement complete? | -- | -- | |
4 | Measure the voltage from the wiper/washer switch (vehicle side) connector terminal E to ground using a DMM. Is the measurement less than 1.0 V (approx. 0 V)? | 1.0 V | Go to Step 8 | Go to Step 5 |
5 |
Is the voltage less than 1.0 V (approx. 0 V)? | 1.0 V | Go to Step 6 | Go to Step 7 |
6 | Replace the wiper motor cover. Refer to Wiper Motor Cover Replacement Is the replacement complete? | -- | -- | |
7 | Repair the short circuit condition to battery in CKT 113. Is the repair complete? | -- | -- | |
8 | Measure the voltage from the wiper/washer switch connector (vehicle side) terminal D to ground using a DMM. Is the measurement less than 1.0 V (approx. 0 V)? | 1.0 V | Go to Step 9 | Go to Step 10 |
9 | Replace the wiper motor cover. Refer to Wiper Motor Cover Replacement Is the replacement complete? | -- | -- | |
10 |
Is the measurement less than 1.0 V (approx. 0 V)? | 1.0 V | Go to Step 11 | Go to Step 12 |
11 | Replace the wiper motor cover. Refer to Wiper Motor Cover Replacement Is the replacement complete? | -- | -- | |
12 | Repair the short circuit condition to battery in CKT 112. Is the repair complete? | -- | -- |
