For 1990-2009 cars only
Adjustment Procedure
- Loosen the bolts for the hood latch.
- Adjust the front hood bumpers on the radiator support until the hood (1) aligns with the front of the fenders. Turn the bumper in the following directions:
- Measure the difference between the hood and the rear of the fender.
- Obtain a shim that is the same thickness as the difference between the hood and the rear of the fender.
- Loosen the hood hinge bolts.
- Install the shim between the hood hinge and the hood.
- Tighten the hood latch bolts by hand until they are snug.
- Position the hood latch upward.
- Tighten the hood latch bolts by hand until they are snug.
- Carefully close the hood in order to engage the following components:
- Adjust the clearance between the hood and fender.
- Carefully open the hood.
- Fully tighten the hood latch bolts.
- Fully tighten the hood hinge bolts.
| • | Clockwise in order to lower the bumper |
| • | Counterclockwise in order to raise the bumper |
| • | The hood striker |
| • | The hood latch |
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the hood latch bolts to 28 N·m (21 lb ft).
Tighten
Tighten the hood latch bolts to 28 N·m (21 lb ft).
