Removal Procedure
- Remove the rear seat cushion. Refer to
Rear Seat Cushion Replacement
.
- Remove the bolt from the
lower U-bracket.
- Lift up the rear seat back bolster to disengage the T-hook from
the access hole in the rear shelf.
- Remove the rear seat back bolster.
Installation Procedure
- Pull the shoulder belt
away from the rear seat back bolster area.
- I.
- Position and engage the T-hook into the access hole in the rear
shelf panel.
- nstall the rear seat back bolster pulling forward on the top edge
of the rear seat back bolster in order to ensure that the attaching hook is
properly engaged.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the seat
back bolster bolt into the lower U-bracket.
Tighten
Tighten the seat back bolster bolt to 12 N·m
(106 lb in).
- Install the rear seat cushion. Refer to
Rear Seat Cushion Replacement
.