The following components secure the front seats to the
floor pan:
| • | Two front hook attachments |
| • | Two rear bolts installed to nuts that are welded to the floor
pan |
The manually operated 2-way front adjusters provide only fore and aft
movement of the seat. The seat adjuster handle is located on the front side
of the seat. When the seat adjuster handle is pulled up, the seat adjusters
unlock. This action permits travel of the seat. When the seat is in the
desired position, and the seat adjuster handle is released, the seat locks
in place.
The power operated 6-way seat adjuster (driver's side only) is activated
by 3 motors with the following characteristics:
| • | Permanent magnet motors |
| • | Built-in circuit breaker |
A switch mounted on the seat cushion outer trim panel energizes the
motors.
The 3 motors drive the following components:
| • | A front vertical actuator |
| • | A rear vertical actuator |
When the adjusters reach the limit of travel, torque is absorbed through
the rubber mounted grommets. The grommets are located between the motor and
the support. The circuit provides an overload relay if you apply excessive
torque to the motor.
