GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 289500  Size: SH
  1. Remove the 2 fuel injector sight shield nuts at the front of the fuel injector sight shield.
  2. Lift the fuel injector sight shield up at the front and slide out of the engine bracket.

Installation Procedure


    Object Number: 289500  Size: SH
  1. Insert the tab of the fuel injector sight shield under the engine bracket.
  2. Lower the fuel injector sight shield.
  3. Align the holes in the fuel injector sight shield with the studs.
  4. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  5. Install the 2 fuel injector sight shield nuts onto the studs.
  6. Tighten
    Tighten the fuel injector sight shield nuts to 3 N·m (27 lb in).