GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

Notice: Handle the oxygen sensors carefully in order to prevent damage to the component. Keep the electrical connector and the exhaust inlet end free of contaminants. Do not use cleaning solvents on the sensor. Do not drop or mishandle the sensor.

Important: Remove the oxygen sensors with the engine temperature above 48°C (120°F). Otherwise the oxygen sensors may be difficult to remove.

Important: A special anti-seize compound is used on the oxygen sensor threads. New service sensors should already have the compound applied to the threads. Coat the threads of a reused sensor with anti-seize compound P/N 5613695 or equivalent.


    Object Number: 602298  Size: SH
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Support the rear of powertrain frame.
  3. Remove the 4 rear frame bolts.
  4. Lower the frame no more than 3 inches.
  5. Disconnect the rear oxygen sensor electrical connector.
  6. Remove the rear oxygen sensor from the rear exhaust manifold.

Installation Procedure

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.


    Object Number: 602298  Size: SH
  1. Install the rear oxygen sensor in the rear exhaust manifold.
  2. Tighten
    Tighten the rear heated oxygen sensor (HO2S) sensor to 41 N·m (30 lb ft).

  3. Connect the rear oxygen sensor connector.
  4. Raise the frame.
  5. Install the 4 rear frame bolts.
  6. Tighten
    Tighten the frame bolts to 100 N·m (74 lb ft).

  7. Lower the vehicle.