Tools Required

J 39400-A Halogen Leak Detector

1. Recover the refrigerant. Refer to Refrigerant Recovery and Recharging .



2. Disconnect the orifice valve wiring harness and position out of the way.



3. Remove the accumulator cover (1).



4. Remove the A/C compressor suction hose (1) from the accumulator.



5. Remove the evaporator hose from the accumulator.
6. Remove the accumulator from the housing.

1. Add the proper amount of refrigerant oil to the accumulator. Refer to Refrigerant System Capacities .
2. Install the accumulator into the housing.




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the evaporator hose and nut to the accumulator.

Tighten
Tighten the nut to 20 N·m (15 lb ft).




4. Install the A/C compressor suction hose (1) and nut to the accumulator.

Tighten
Tighten the nut to 20 N·m (15 lb ft).




5. Install the accumulator cover (1).



6. Install the evaporator hose into the retainer.
7. Recharge the A/C system. Refer to Refrigerant Recovery and Recharging .
8. Leak test the fittings of the component using the J 39400-A .