For 1990-2009 cars only
Removal Procedure
- Remove the upper door trim panel (1) located above the door trim panel.
- Remove the sound barrier.
- Remove the door trim panel to gain access to the power mirror wire harness. Refer to Front Side Door Trim Panel Replacement .
- Disconnect the electrical connector.
- Remove the mirror fasteners.
- Disconnect the wire harness from the retainer clip and unseat the grommet.
- Remove the mirror from the door.
- Pull the wiring harness through the hole in the mirror patch.
| 1.1. | Use the J-tool to release retainer at the top of the panel. |
| 1.2. | Lift the panel up to remove. |
| 1.3. | Disconnect the wire harness from the tweeter. |
Installation Procedure
- Route the mirror wiring harness through the hole in the mirror patch.
- Install the mirror into the door frame.
- Install the mirror fasteners.
- Install the grommet by gently pulling into place.
- Connect the electrical connectors.
- Install the mirror wire harness into retainer clip.
- Install the sound barrier.
- Install the door trim panel. Refer to Front Side Door Trim Panel Replacement .
- Install the upper door trim panel (1).
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the mirror fasteners to 9 N·m (80 lb in).
| 9.1. | Connect the wire harness to the tweeter. |
| 9.2. | Insert the tabs into the slots on the door trim. |
| 9.3. | Push the x-mas tree retainer into the door. |
