Removal Procedure
- Remove the door trim panel. Refer to Front Side Door Trim Panel Replacement .
- Remove the water deflector. Refer to Front Side Door Water Deflector Replacement .
- Partially open the window.
- Disconnect the power window motor electrical connector (2).
- Remove the fasteners (1) securing the power window motor to the window regulator.
- Remove the power window motor (3).
Important: There is a binding effect on the power window motor drive when the window is in the fully closed or open position.
Installation Procedure
- Install the power window motor (3) to the window regulator.
- Install the power window motor to regulator fasteners (1).
- Connect the electrical connector (2).
- Inspect for proper operation of the power window motor and window.
- Install the water deflector. Refer to Front Side Door Water Deflector Replacement .
- Install the door trim panel. Refer to Front Side Door Trim Panel Replacement .
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the power window motor fasteners to 4 N·m
(62 lb in).
