Engine Oil Pressure Sensor or Switch Replacement w/L47

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Disconnect the electrical connector (2) from the oil pressure switch (1).
3. Remove the oil pressure switch (1) from the oil filter adapter (3).

Notice: Refer to Component Fastener Tightening Notice in the Preface section.




1. Install the oil pressure switch (1) to the oil filter adapter (3).

Tighten
Tighten the oil pressure switch to 16 N·m (12 lb ft).

2. Connect the electrical connector (2) to the oil pressure switch (1).
3. Lower the vehicle.
4. Adjust the engine oil level to the full mark.
5. Inspect for oil leaks after engine start up.

Engine Oil Pressure Sensor or Switch Replacement w/LX5

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Disconnect the electrical connector from the oil pressure switch.
3. Remove the oil pressure switch.

Notice: Refer to Component Fastener Tightening Notice in the Preface section.




1. Install the engine oil pressure switch.

Tighten
Tighten the engine oil pressure switch to 10 N·m (89 lb in).

2. Connect the electrical connector to the oil pressure switch.
3. Lower the vehicle.
4. Inspect for oil leaks after engine start up.
5. Adjust the engine oil level to the full mark.