Tools Required

J 24319-B Steering Linkage and Tie Rod Puller

1. Remove the rear suspension support assembly. Refer to Support Replacement .
2. Remove the automatic level control height sensor link on the left control arm.



3. Remove the stabilizer link bolt and the nut.
4. Disconnect the antilock brake electrical connector.
5. Remove the wheel bearing and hub . Refer to Rear Wheel Bearing and Hub Replacement .



6. Remove the adjustment link retaining nut from the lower control arm.



7. Using J 24319-B , separate the adjustment link from the lower control arm.



8. Remove the bolt and the nut securing the lower control arm to the rear suspension support assembly.
9. Remove the lower control arm.

1. Install the lower control arm to the rear suspension support assembly.

Important: Tighten the control arm nuts with the vehicle unsupported and resting on the wheels at the normal trim height.

2. Install the lower control arm bolts and the nuts.
3. Install the wheel bearing and hub, if necessary. Refer to Rear Wheel Bearing and Hub Replacement .
4. Connect the antilock brake electrical connector.



5. Install the adjustment link to the lower control arm.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

6. Install the adjustment link retaining nut.

Tighten
Tighten the adjustment link retaining nut to 30 N·m (22 lb ft) plus an additional 180 degrees.




7. Install the stabilizer link bolt and the nut.

Tighten
Tighten the stabilizer link nut to 15 N·m (11 lb ft).

8. Install the automatic level control height sensor link on the left control arm.
9. Install the rear suspension support assembly. Refer to Support Replacement .
10. Lower the vehicle.

Tighten
Tighten the control arm nuts to 106 N·m (78 lb ft).