Tools Required

J 24319-B Steering Linkage and Tie Rod Puller

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Support the control arm with a jack stand.
3. Remove the automatic level control air tube from the shock.
4. Remove the lower shock absorber lower retaining bolts.



5. Remove the adjustment link retaining nut.

Notice: When separating a linkage joint, DO NOT try to disengage the joint by driving a wedge between the joint and the attached part. Seal Damage may result.




6. Using J 24319-B separate the adjustment link from the lower control arm.
7. Slowly lower the control arm onto the support assembly.



8. Pry under the lower spring insulator. Remove the spring with the insulator.
9. Remove the jounce bumper, if necessary, by pulling downward.

1. Install the jounce bumper by inserting the retainer into the body of the vehicle.
2. Install the spring and the lower insulator. Ensure that the insulator is seated in the control arm.




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Raise the lower control arm.
4. Install the lower shock absorber retaining bolts.

Tighten
Tighten the lower shock absorber retaining bolts to 24 N·m (18 lb ft).




5. Install the adjustment link to the lower control arm.
6. Install the adjustment link retaining nut.

Tighten
Tighten the nut to 30 N·m (22 lb ft) plus an additional 180 degrees.

7. Install the automatic level control air tube to the shock.
8. Install the tire and the wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
9. Lower the vehicle.