Removal Procedure
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Remove the right rear wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
- Remove the right rear fascia extension. Refer to Rear Bumper Fascia Extension Replacement in Bumpers.
- Disconnect the air tube from the air dryer.
- Remove the bolt and the harness tie with the air tube from the air compressor bracket.
- Remove the intake air filter from the vehicle.
- Disconnect the air compressor connector.
- Remove the 2 nuts, the bolt, and the air compressor from the vehicle.
- Slide the air compressor connector off of the connector anchor.
- Remove 2 bolts and the heat shield from the air compressor bracket.
- Remove 3 bolts and the air compressor from the bracket.
- Remove the air dryer from the air compressor. Refer to Automatic Level Control Air Dryer Replacement .
- Disconnect the air hose from the air compressor.
- Remove the 2 screws and the 2 brackets from the air compressor.
Important: Before disconnecting the air hose from the intake air filter or the air compressor, clean the components and the surrounding area to prevent dirt and other foreign material from entering the ELC system.
Installation Procedure
- Install the 2 brackets on the air compressor with 2 screws.
- Connect the air hose to the air compressor.
- Install the air dryer on the air compressor. Refer to Automatic Level Control Air Dryer Replacement .
- Install the air compressor onto the bracket with 3 bolts.
- Install the heat shield on the air compressor bracket with 2 bolts (Do not install the third heat shield bolt. It must be installed after the air tube is connected).
- Install the air compressor connector to the connector anchor.
- Install the air compressor on the vehicle with 2 nuts and a bolt.
- Connect the air compressor connector.
- Install the intake air filter on the vehicle.
- Connect the air tube to the air dryer.
- Connect the air tube and the harness tie to the air compressor bracket with the bolt.
- Install the right rear fascia extension. Refer to Rear Bumper Fascia Extension Replacement in Bumpers.
- Install the right rear wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
- Lower the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the screws to 7 N·m (62 lb in).
Tighten
Tighten the bolts to 3 N·m (26 lb in).
Tighten
Tighten the bolts to 4 N·m (35 lb in).
Tighten
| • | Tighten the bolt to 9 N·m (80 lb in). |
| • | Tighten the nuts to 9 N·m (80 lb in). |
Tighten
Tighten the bolt to 4 N·m (35 lb in).
Important: Before driving the vehicle, turn the ignition on and wait approximately 45 seconds. This will ensure that the air adjustable shock absorbers are filled with residual pressure.
