Schematic Reference: Exterior Lights Schematics

Connector End View Reference: Master Electrical Component List in Wiring Systems

1

Did you perform the Lighting System Diagnostic System Check?

Go to Step 2

Go to Diagnostic System Check - Lighting Systems

1. Turn ON the ignition, with the engine OFF.
2. Observe the hazard lamps.
3. Turn ON the hazard lamp switch.
4. Turn OFF the hazard lamp switch.
5. Turn OFF the ignition.

Did the hazard lamps operate properly?

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

1. Disconnect the driver information center (DIC).
2. Turn ON the ignition a with engine OFF.

Did the hazard flashers turn off?

Go to Step 5

Go to Step 4

Test the hazard switch signal circuit for a short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 9

Go to Step 6

Inspect for poor connections at the harness of the DIC. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 9

Go to Step 7

Inspect for poor connections at the harness connector of the turn signal/hazard flasher module. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 9

Go to Step 8

Replace the DIC. Refer to Driver Information Center Module Replacement in Instrument Panel, Gages and Console.

Did you complete the replacement?

Go to Step 9

--

Replace the turn signal/hazard flasher module. Refer to Hazard and Turn Signal Flasher Replacement .

Did you complete the replacement?

Go to Step 9

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 2