GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Oldsmobile 🢒 2003 🢒 Aurora 🢒 Body and Accessories 🢒 Instrument Panel, Gages, and Console 🢒 Accelerator Control Cable Bracket Replacement

Removal Procedure

    Object Number: 104766 Size: SH
  1. Remove the cruise control cable (2) from the accelerator controls cable bracket (1).
  2. Remove the accelerator cable (3) from the accelerator controls cable bracket (1).

    3. Object Number: 104763 Size: SH
  3. Remove the fuel feed and return pipes from the accelerator controls cable bracket (1) retainer.

    4. Object Number: 154854 Size: SH
  4. Remove the transaxle vent hose (2) clip from the accelerator controls cable bracket (1).

    5. Object Number: 189069 Size: SH
  5. Remove the transaxle shift cable clip from the accelerator controls cable bracket.

    6. Object Number: 18918 Size: SH
  6. Remove the bolts from the accelerator controls cable bracket.

Installation Procedure

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.


    Object Number: 18918 Size: SH
  1. Install the accelerator controls cable bracket.

    2. Tighten
    Tighten the bolts to 12 N·m (106 lb in).


    Object Number: 189069 Size: SH
  2. Install the transaxle shift cable clip to the accelerator controls cable bracket.

    3. Object Number: 154854 Size: SH
  3. Install the transaxle vent hose (2) clip to the accelerator controls cable bracket (1).

    4. Object Number: 104763 Size: SH
  4. Install the fuel feed and return pipes to the accelerator controls cable bracket (1) retainer.

    5. Object Number: 104766 Size: SH
  5. Install the accelerator cable (3) to the accelerator controls cable bracket (1).

    6. Important: Ensure that cables are not rubbing or binding in any manner. The throttle should operate freely without bind between full closed and wide open throttle.

  6. Install the cruise control cable (2) to the accelerator controls cable bracket (1).