Schematic Reference: Audible Warnings Schematics

1

Did you perform the Audible Warnings Diagnostic System Check?

Go to Step 2

Go to Diagnostic System Check - Audible Warnings

Do any indicators or messages illuminate when the chime sounds?

Go to Symptoms - Instrument Panel, Gages and Console

Go to Step 3

1. Turn the ignition OFF.
2. Remove the key from the ignition.
3. Turn the headlamp switch to OFF.
4. Open the driver door.

Does the chime sound?

Go to Step 4

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

With a scan tool, observe the Park Lamp parameter in the DIM Inputs list.

Does the Park Lamp parameter display Off?

Go to Step 6

Go to Step 5

1. Turn the ignition OFF.
2. Disconnect the DIM connector C2.
3. Connect a test lamp between the park lamp switch on signal circuit and a battery positive voltage.

Does the test lamp illuminate?

Go to Step 8

Go to Step 14

1. With a scan tool, observe the Key-in-Ignition parameter in the IPM Non-HVAC Data list.
2. Turn the ignition OFF.
3. Remove the key from the ignition.

Does the Key-in-Ignition parameter display No?

Go to Step 16

Go to Step 7

1. Turn the ignition OFF.
2. Remove the key from the ignition.
3. Disconnect the IPM connector C1.
4. Connect a test lamp between the key in ignition signal circuit and battery positive voltage.

Does the test lamp illuminate?

Go to Step 9

Go to Step 15

Test the park lamp switch on signal circuit for a short to ground. Refer to Circuit Testing and to Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 17

Go to Step 10

Test the key in ignition signal switch circuit for a short to ground. Refer to Circuit Testing and to Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 17

Go to Step 11

Inspect for poor connections at the harness connector of the headlamp switch. Refer to Testing for Intermittent Conditions and Poor Connections and to Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 17

Go to Step 12

Inspect for poor connections at the harness connector of the ignition key alarm switch. Refer to Testing for Intermittent Conditions and Poor Connections and to Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 17

Go to Step 13

Replace the headlamp switch. Refer to Headlamp Switch Replacement in Lighting Systems.

Did you complete the replacement?

Go to Step 17

--

Replace the ignition switch. Refer to Ignition and Start Switch Replacement .

Did you complete the replacement?

Go to Step 17

--

Important: Program the replacement DIM.

Replace the dash integration module (DIM). Refer to Dash Integration Module Replacement in Body Control System.

Did you complete the replacement?

Go to Step 17

--

Replace the instrument panel integration module. Refer to Instrument Panel Module Replacement in Body Control System.

Did you complete the replacement?

Go to Step 17

--

Important: Perform the set up procedure for the radio.

Replace the radio. Refer to Radio Replacement in Entertainment.

Did you complete the replacement?

Go to Step 17

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 2