Test Description
The number(s) below refer to the step number(s) on the diagnostic table.
-
Lack of communication may be due to a partial malfunction of the class 2 serial data circuit or due to a total malfunction of the class 2 serial data circuit. The specified procedure will determine the particular condition.
-
The symptoms list in Symptoms will determine the correct diagnostic procedure to use.
-
The presence of DTCs which begin with "U" indicate some other module is not communicating. The specified procedure will compile all the available information before tests are performed.
-
At this point you have determined all DTCs applicable to the horn system. Refer to Symptoms - Horns for further horn system diagnosis. Any other codes displayed from the listed modules do not apply to horns and should be diagnosed in the applicable section.
Step | Action | Yes | No |
|---|---|---|---|
1 | Install a scan tool. Does the scan tool power up? | Go to Step 2 | Go to Scan Tool Does Not Communicate with Class 2 Device in Data Link Communications |
Does the scan tool communicate with the DIM? | Go to Step 3 | Go to Scan Tool Does Not Communicate with Class 2 Device in Data Link Communications | |
Select the DIM display DTCs function on the scan tool. Does the scan tool display any DTCs? | Go to Step 4 | Go to Symptoms - Horns | |
Does the scan tool display any DTCs which begin with a "U"? | Go to Scan Tool Does Not Communicate with Class 2 Device in Data Link Communications | Go to Step 5 | |
5 | Does the scan tool display DTC B1000, B1004, B1007, B1009 or B1010? | Go to Diagnostic Trouble Code (DTC) List in Body Control System | Go to Step 6 |
Does the scan tool display DTC B1327? | Go to Diagnostic Trouble Code (DTC) List in Engine Electrical | Go to Symptoms - Horns |
