For 1990-2009 cars only
Removal Procedure
- Lower the window all the way down.
- Remove the door trim panel. Refer to Rear Side Door Trim Panel Replacement .
- Remove the door module. Refer to Door Control Module Replacement .
- Remove the water deflector. Refer to Rear Side Door Water Deflector Replacement .
- Remove the window inner belt sealing strip. Refer to Rear Door Window Belt Inner Sealing Strip Replacement .
- Loosen the window regulator to window clamps.
- Remove the window by lifting up and out.
Installation Procedure
- Install the window down into the door assembly making sure the window is in the run channels.
- Locate the window into the two window regulator to window clamps.
- Install the window inner belt sealing strip. Refer to Rear Door Window Belt Inner Sealing Strip Replacement .
- Connect a power source to the window motor and run the window to the full up position.
- Install water deflector. Refer to Rear Side Door Water Deflector Replacement .
- Install the door module. Refer to Door Control Module Replacement .
- Install the door trim panel. Refer to Rear Side Door Trim Panel Replacement .
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the window clamp fasteners to 11 N·m (98 lb in).
