Removal Procedure
- Lower the window half way down in order to gain access to the window retainer clamp fasteners (1).
- Remove the door trim panel. Refer to Rear Side Door Trim Panel Replacement .
- Remove the door module. Refer to Door Control Module Replacement .
- Remove the water deflector. Refer to Rear Side Door Water Deflector Replacement .
- Loosen the window retainer clamp fasteners.
- Slide the window to the full up position.
- Disconnect the electrical connector from the motor.
- Remove the window regulator to inner door panel fasteners (1-3).
- Remove the window regulator.
Important: You may need to use masking tape in order to hold the window in place while removing the regulator.
Installation Procedure
- Install the window regulator into the door.
- Install the window regulator fasteners.
- Provide power to the window motor and run the motor to the fully closed position.
- Connect the window motor electrical connector.
- Install the water deflector. Refer to Rear Side Door Water Deflector Replacement .
- Install the door module. Refer to Door Control Module Replacement .
- Install the door trim panel. Refer to Rear Side Door Trim Panel Replacement .
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the fasteners in this order, (1, 3, 2),
to 9 N·m (80 lb in).
Tighten
Tighten the window retainer clamp fasteners to 11 N·m (95 lb in).
