For 1990-2009 cars only
Removal Procedure
- Remove the door trim panel. Refer to Rear Side Door Trim Panel Replacement .
- Remove the door module. Refer to Door Control Module Replacement .
- Remove the water deflector. Refer to Rear Side Door Water Deflector Replacement .
- Remove the fastener (2) from the inside door handle.
- Slide the inside door handle forward to release the tabs (4) from the door.
- Tilt the handle and remove the rods from the handle in the following sequence:
| 6.1. | Lock knob rod (1) |
| 6.2. | Handle lever rod (2) |
Installation Procedure
- Install the rods to the inside door handle in the following sequence:
- Guide the tabs (4) on the inside door handle into the slots in the door.
- Slide the inside door handle rearward to engage tabs.
- Install the inside door handle fastener (2).
- Install the water deflector. Refer to Rear Side Door Water Deflector Replacement .
- Install the door module. Refer to Door Control Module Replacement .
- Install the door trim panel. Refer to Rear Side Door Trim Panel Replacement .
| 1.1. | Handle lever rod (2) |
| 1.2. | Lock knob rod (1) |
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the fastener to 2 N·m (18 lb in).
