Throttle Position Sensor Replacement RPO L35

1. Remove the electrical connector by releasing the locking tab.



2. Remove the 2 TP sensor attaching screw assemblies.

Notice: The TP sensor is an electrical component. Do not soak the TP sensor in any liquid cleaner or solvent as damage may result.




3. Remove the TP sensor from the throttle body assembly.

1. With the throttle valve closed, install the TP sensor on the throttle shaft.

Rotate the TP sensor counterclockwise in order to align the mounting holes.




2. Install the 2 TP sensor attaching screw assemblies.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

Tighten
Tighten the screw assemblies to 2.0 N·m (18.0 lb in).




3. Install the electrical connector.