GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Oldsmobile 🢒 2000 🢒 Bravada 🢒 Engine 🢒 Engine Controls - 4.3L 🢒 Secondary Air Injection Pump Replacement

Removal Procedure
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. For a 2WD vehicle, skip steps 6 and 7.

    3. For a 4WD vehicle, skip steps 4 and 5.


    Object Number: 372939 Size: SH
  3. Remove the AIR shield mounting bolts.

    4. Object Number: 372933 Size: SH
  4. Remove the AIR shield.

    5. Object Number: 325346 Size: SH
  5. Remove the retaining bolts from the steering linkage shield.

    6. Object Number: 325348 Size: SH
  6. Remove the steering linkage shield.

    7. Object Number: 373100 Size: SH
  7. Remove the AIR injection reactor pipe assembly from the pump assembly by loosening the spring clamp.

    8. Object Number: 379908 Size: SH
  8. Remove the AIR injection reactor pump hose from the pump assembly by loosening the spring clamp.

    9. Object Number: 379909 Size: SH
  9. Disconnect the AIR pump and solenoid electrical connectors.

    10. Object Number: 373107 Size: SH
  10. Remove the AIR pump mounting bolts.

    11. Object Number: 373104 Size: SH
  11. Remove the AIR pump.

Installation Procedure

    Object Number: 373104 Size: SH
  1. Align the AIR pump bracket with the mounting holes.

    2. Object Number: 373107 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the AIR pump mounting bolts.

    3. Tighten
    Tighten the bolts to 17 N·m (13 lb ft).


    Object Number: 379909 Size: SH
  3. Connect the AIR pump and solenoid electrical connectors.

    4. Object Number: 379908 Size: SH
  4. Connect the AIR injection reactor pump hose to the pump assembly with a hose clamp.

    5. Object Number: 373100 Size: SH
  5. Install the AIR injection reactor pipe assembly to the pump assembly with a hose clamp.
  6. For a 2WD vehicle, skip steps 9 and 10.

    7. For a 4WD vehicle, skip steps 7 and 8.


    Object Number: 372933 Size: SH
  7. Align the AIR shield.

    8. Object Number: 372939 Size: SH
  8. Install the AIR shield mounting bolts.

    9. Tighten
    Tighten the bolts to 33 N·m (24 lb ft).


    Object Number: 325348 Size: SH
  9. Align the steering linkage shield.

    10. Object Number: 325346 Size: SH
  10. Install the linkage shield mounting bolts.

    11. Tighten
    Tighten the bolts to 33 N·m (24 lb ft).

  11. Lower the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.