1. Remove the interior trim panel. Refer to Endgate Trim Panel Replacement or Liftgate Trim Panel Replacement in Body Rear End.
2. Remove two screws and the wiper arm park ramp from the vehicle.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

1. Install the wiper arm park ramp under the wiper arm and onto the vehicle with two screws.

Tighten
Tighten two screws to 9 N·m (80 lb in).

2. Install the interior trim panel. Refer to Endgate Trim Panel Replacement or Liftgate Trim Panel Replacement in Body Rear End.