Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Was the BCM Diagnostic System Check performed? | -- | Go to Step 2 | Go to Diagnostic System Check - Body Control System in Body Control System |
2 | Did you review the audible warnings system operation and perform the necessary inspections? | -- | Go to Step 3 | |
3 | Verify that the chime is always on. Does the chime operate normally? | -- | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 4 |
4 |
Does the KEY IN IGNITION test display NO? | -- | Go to Step 5 | Go to Step 9 |
5 |
Does the PARKLAMPS test display OFF? | -- | Go to Step 6 | Go to Step 10 |
6 | Inspect the connections at the BCM. Refer to Testing for Intermittent Conditions and Poor Connections in Wiring Systems. Are the connections in need of repair? | -- | Go to Step 7 | Go to Step 8 |
7 | Repair the connections as necessary. Refer to Connector Repairs in Wiring Systems. Is the repair complete? | -- | Go to Step 11 | -- |
8 | Replace the BCM. Refer to Body Control Module Replacement in Body Control System. Is the repair complete? | -- | Go to Step 11 | -- |
9 | Locate and repair the short to ground in CKT 80 between the BCM connector C2 terminal B9 and the ignition key alarm switch. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Is the repair complete? | -- | Go to Step 11 | -- |
10 | Are the park lamps ON with the switch OFF? | -- | Go to Diagnostic Starting Point in Lighting Systems | Go to Step 6 |
11 | Operate the system in order to verify the repair. Did you correct the condition? | -- | System OK | Go to Step 4 |
