Front Bumper Fascia Replacement Xtreme

1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Disconnect the electrical connector from the fog lamps.
3. Remove the push-pins that retain the fascia to the impact bar.
4. Remove the screws that retain the fascia to the fascia support.
5. Remove the fascia from the impact bar retainers.
6. Remove the fascia from the vehicle.
7. Remove the front fog lamps from the fascia. Refer to Front Fog Lamp Replacement in Lighting Systems.

1. Install the front fog lamp to the fascia. Refer to Front Fog Lamp Replacement in Lighting Systems.
2. Install the front fascia to the vehicle.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the fascia screws to the impact bar retainers.

Tighten
Tighten the fascia screws to 1.9 N·m (17 lb in).

4. Install the push-pins that retain the fascia to the impact bar.
5. Connect the electrical connector to the fog lamps.
6. Lower the vehicle.

Front Bumper Fascia Replacement GMC

1. Remove the grille. Refer to Grille Replacement in Exterior Trim.



2. Disengage the retainers in order to remove the retainers from the fascia.
3. Remove the front bumper fascia from the vehicle.

1. Install the front bumper fascia to the vehicle.
2. Install the fascia retainers. Ensure that the retainers lock into position.
3. Install the grille. Refer to Grille Replacement in Exterior Trim.

Front Bumper Fascia Replacement GMC

1. Remove the grille. Refer to Grille Replacement in Exterior Trim.



2. Remove the push-pin retainers attaching the fascia to the front bumper.
3. Remove the front bumper fascia from the vehicle.

1. Install the front bumper fascia to the vehicle.
2. Install the push-pin fascia retainers. Ensure that the retainers lock into position.
3. Install the grille. Refer to Grille Replacement in Exterior Trim.