GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

Caution: Refer to Brake Dust Caution in the Preface section.


    Object Number: 748566  Size: SH
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  3. Inspect the brake caliper assembly. Refer to Brake Caliper Inspection .
  4. Notice: Support the brake caliper with heavy mechanic wire, or equivalent, whenever it is separated from its mount and the hydraulic flexible brake hose is still connected. Failure to support the caliper in this manner will cause the flexible brake hose to bear the weight of the caliper, which may cause damage to the brake hose and in turn may cause a brake fluid leak.

  5. Remove the rear brake caliper assembly, relocate the brake caliper to the side. Refer to Rear Brake Caliper Replacement .
  6. Inspect the brake pads. Refer to Brake Pad Inspection .

  7. Object Number: 748557  Size: SH
  8. Remove the front brake pads from the mounting bracket.
  9. Inspect the brake hardware. Refer to Front Disc Brake Mounting and Hardware Inspection .

  10. Object Number: 748563  Size: SH
  11. Remove the brake pad retaining clips from the mounting bracket.

  12. Object Number: 783128  Size: SH
  13. Remove the brake caliper mounting bracket retaining bolts.

  14. Object Number: 748570  Size: SH
  15. Remove the brake caliper mounting bracket.

  16. Object Number: 788344  Size: SH
  17. Remove the guide pin seals from the brake caliper mounting bracket.
  18. Inspect the brake rotor. Refer to Brake Rotor Surface and Wear Inspection .

Installation Procedure


    Object Number: 788344  Size: SH
  1. Install the guide pin seals on the mounting bracket.
  2. If the guide pins and brake pad retaining clips are to be reused, use denatured alcohol to clean them.
  3. Dry the brake guide pins and brake pad retaining clips with non-lubricated, filtered air.

  4. Object Number: 156329  Size: SH
  5. Apply high temperature silicone brake lubricant to the brake caliper guide pins. DO NOT apply the lubricant to the brake pad retaining clips.

  6. Object Number: 748570  Size: SH
  7. Install the brake caliper mounting bracket.
  8. Notice: Refer to Fastener Notice in the Preface section.

  9. Install the caliper mounting bracket bolts.
  10. Tighten
    Tighten the caliper mounting bracket bolts to 200 N·m (148 lb ft).


    Object Number: 748563  Size: SH
  11. Install the rear brake pad hardware to the brake caliper mounting bracket.

  12. Object Number: 748557  Size: SH
  13. Install the brake pads to the brake caliper mounting bracket.

  14. Object Number: 748566  Size: SH
  15. Install the rear brake caliper assembly. Refer to Rear Brake Caliper Replacement
  16. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  17. Lower the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  18. Caution: Refer to Firm Brake Pedal Caution in the Preface section.

  19. Pump the brake pedal slowly and firmly in order to seat the brake pads.