GM Service Manual Online
For 1990-2009 cars only

Step

Action

Yes

No

Schematic Reference: Exterior Lights Schematics

1

Did you perform the Lighting Systems Diagnostic System Check?

Go to Step 2

Go to Diagnostic System Check - Lighting Systems

2

Verify that the park, license and tail lamps are inoperative.

Do the park, license and tail lamps operate normally?

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

3

  1. Remove the park lamp relay.
  2. Ensure that the headlamp switch is in the HEAD position.
  3. Test for a ground signal at the park lamp relay control circuit terminal in the body relay block. Refer to Circuit Testing in Wiring Systems.

Was a ground signal present?

Go to Step 8

Go to Step 4

4

Use the scan tool to check the body control module (BCM) parklamp switch input data.

Does the scan tool indicate a park lamps ON request signal?

Go to Step 7

Go to Step 5

5

Test for an open or high resistance in the park lamp switch signal circuit. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 11

Go to Step 6

6

Inspect for poor connections at the harness connector of the headlamp switch. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 11

Go to Step 9

7

Inspect for poor connections at the harness connector of the BCM. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 11

Go to Step 10

8

Replace the park lamp relay. Refer to Park Lamp Relay Replacement .

Did you complete the repair?

Go to Step 11

--

9

Replace the headlamp switch. Refer to Headlamp Switch Replacement .

Did you complete the repair?

Go to Step 11

--

10

Important: Perform the setup procedure for the BCM.

Replace the body control module (BCM). Refer to Body Control Module Replacement in Body Control System.

Did you complete the replacement?

Go to Step 11

--

11

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 3