Schematic Reference: Power Window Schematics

Connector End View Reference: Power Door Systems Connector End Views or Body Control System Connector End Views in Body Control System

Did you perform the Door Systems Diagnostic System Check?

Go to Step 2

Go to Diagnostic System Check - Door Systems

1. Disable the window lockout function.
2. Operate the passenger power windows from the passenger door power window switches.

Do the passenger power windows operate normally?

Go to Step 3

Go to Power Window Inoperative - Passenger Door

1. Enable the window lockout function.
2. Operate the passenger power windows from the passenger door power window switches.

Do the passenger power windows operate up and down?

Go to Step 4

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

1. Install a scan tool.
2. Monitor the window lockout data parameter in the driver door module input list.
3. Place the window lockout switch in both the ON and OFF positions.

Does the window lockout data parameter change accordingly?

Go to Step 5

Go to Step 10

Does the window lockout function for the front passenger power window operate properly?

Go to Step 6

Go to Step 9

1. Disable the window lockout function.
2. Disconnect the appropriate rear window switch.
3. Connect a test lamp to a good ground.
4. Probe the rear window lockout signal circuit at the rear window switch harness connector.

Does the test lamp illuminate?

Go to Step 7

Go to Step 11

Test for a short to battery positive voltage on the rear window lockout signal circuit. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 16

Go to Step 8

Inspect for poor connections at the body control module. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 16

Go to Step 12

Inspect for poor connections at the passenger door module. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 16

Go to Step 13

Inspect for poor connections at the driver door module. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 16

Go to Step 14

Inspect for poor connections at the rear power window switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 16

Go to Step 15

Important: Perform the set up procedure for the body control module. Refer to Body Control Module (BCM) Programming/RPO Configuration in Body Control System.

Replace the body control module. Refer to Body Control Module Replacement In Body Control System.

Did you complete the repair?

Go to Step 16

--

Important: Perform the set up procedure for the passenger door module. Refer to Service Programming System (SPS) in Programming.

Replace the passenger door module. Refer to Door Lock and Side Window Switch Replacement - Passenger Side .

Did you complete the repair?

Go to Step 16

--

Important: Perform the set up procedure for the driver door module. Refer to Service Programming System (SPS) in Programming.

Replace the driver door module. Refer to Door Lock and Side Window Switch Replacement - Driver Side .

Did you complete the repair?

Go to Step 16

--

Replace the rear power window switch. Refer to Rear Side Door Window Switch Replacement .

Did you complete the repair?

Go to Step 16

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 2