Circuit Description
The driver door module supplies battery positive voltage to the power mirror switch. When the mirror select switch is placed in the left or right mirror position, the appropriate signal circuit is switched to 12 volts. The driver door module senses the voltage change and allows control of the selected outside rearview mirror.
Conditions for Running the DTC
| • | Battery voltage must be between 9.0-16.0 volts. |
| • | The ignition switch is in the ON position. |
Conditions for Setting the DTC
The driver door module senses an active state on both mirror select switch circuits greater than 3 seconds.
Action Taken When the DTC Sets
The driver door module ignores the continuous inputs from the switch. The driver door module will respond to all other valid switch inputs.
Conditions for Clearing the DTC
When the fault is no longer present, the door module changes the current DTC to a history DTC. The door module will clear the history DTC after 50 fault free ignition cycles, or in a response to a scan tool command.
Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
Schematic Reference: Outside Rearview Mirror Schematics Connector End View Reference: Power Door Systems Connector End Views | ||||
1 | Did you perform the Door Systems Diagnostic System Check? | -- | Go to Step 2 | |
2 |
Does the scan tool display Netural/Fold? | -- | Go to Step 3 | Go to Step 4 |
3 |
Does the Mirror Select switch data parameter change state appropriatly with each selection? | -- | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 4 |
4 |
Does the scan tool display Netural/Fold? | -- | Go to Step 7 | Go to Step 5 |
5 | Inspect for poor connections at the harness connector of the driver door module. Refer to Testing for Intermittent Conditions and Poor Connections in Wiring Systems. Did you find and correct the condition? | -- | Go to Step 8 | Go to Step 6 |
6 |
Important: Perform the set up procedure for the driver door module. Refer to Service Programming System (SPS) in Programming. Replace the driver door module. Refer to Door Lock and Side Window Switch Replacement - Driver Side . Did you complete the replacement? | -- | Go to Step 8 | -- |
7 | Replace the mirror switch. Refer to Power Mirror Switch Replacement . Did you complete the replacement? | -- | Go to Step 8 | -- |
8 |
Does the DTC reset? | -- | Go to Step 2 | System OK |
