GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Oldsmobile 🢒 2004 🢒 Bravada - 2WD 🢒 Accessories 🢒 Navigation Systems 🢒 Radio Replacement

Removal Procedure
  1. Remove the center console shift lever bezel (Oldsmobile only). Refer to Console Shift Lever Bezel Replacement in Instrument Panel, Gages and Console.
  2. Remove the lower closeout/insulator panel (GMC only). Refer to Instrument Panel Insulator Panel Replacement in Instrument Panel, Gages and Console.
  3. Remove the accessory trim plate. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement or Instrument Panel Accessory Trim Plate Replacement in Instrument Panel, Gages and Console.

    4. Object Number: 718020 Size: SH
  4. Remove the 3 screws that retain the radio to the I/P.
  5. Partially remove the radio disengaging the radio rear alignment locator (1) to gain access to the electrical connectors.
  6. Disconnect the radio antenna cable.
  7. Disconnect the electrical connectors to the radio.
  8. Remove the radio from the vehicle.

Installation Procedure

    Object Number: 718020 Size: SH
  1. Position the radio to the I/P.
  2. Connect the electrical connectors to the radio.
  3. Connect the radio antenna cable to the radio.
  4. Position the radio rear alignment locator (1) into the I/P substrate.

    5. Notice: Refer to Fastener Notice in the Preface section.

  5. Install the 3 screws that retain the radio to the I/P.

    6. Tighten
    Tighten the screws to 2 N·m (18 lb in).

  6. Install the accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement or Instrument Panel Accessory Trim Plate Replacement in Instrument Panel, Gages and Console.
  7. Install the lower closeout/insulator panel (GMC only). Refer to Instrument Panel Insulator Panel Replacement in Instrument Panel, Gages and Console.
  8. Install the center console shift lever bezel (Oldsmobile only). Refer to Console Shift Lever Bezel Replacement in Instrument Panel, Gages and Console.
  9. Perform the radio setup - if equipped with UM8, refer to Radio Setup . Refer to Service Programming System (SPS) in Programming for all other audio system configurations for setup.