Evaporative Emission Canister Purge Solenoid Valve Replacement for Oldsmobile Cutlass 1998

Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.




1. Remove the negative battery cable.
2. Note the position of the hoses for installation.
3. Remove the electrical connector and hoses from solenoid.
4. Release the lock tab on the solenoid mounting bracket.
5. Remove the solenoid.

1. Bend tab on mounting bracket to retain the EVAP purge solenoid valve.
2. Install the solenoid to solenoid mounting bracket.

Once installed pull on the solenoid to ensure that the part will be held in place.

3. Install the electrical connector and hoses to solenoid.
4. Connect the negative battery cable.