GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Oldsmobile 🢒 1998 🢒 Cutlass 🢒 Engine 🢒 Engine Controls - 2.4L 🢒 Fuel Level Sensor Replacement

Removal Procedure

    Object Number: 61936 Size: SH
  1. Relieve fuel system pressure. Refer to Fuel Pressure Relief .
  2. Drain the fuel tank. Refer to Fuel Tank Draining .
  3. Remove the fuel tank. Refer to Fuel Tank Replacement .
  4. Remove the modular fuel sender assembly. Refer to Fuel Sender Assembly Replacement .
  5. Remove the fuel level sensor from the modular fuel sender.

Installation Procedure

    Object Number: 61936 Size: SH
  1. Install the fuel level sensor to modular fuel sender.
  2. Install the fuel sender assembly. Refer to Fuel Sender Assembly Replacement .
  3. Install the fuel tank. Refer to Fuel Tank Replacement .
  4. Refill the fuel tank.

    5. Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

  5. Connect the negative battery cable.
  6. Inspect for fuel leaks through the following steps:
    7. 6.1. Turn the ignition switch to the ON position for two seconds.
    6.2. Turn the ignition switch to the OFF position for ten seconds.
    6.3. Turn the ignition switch to the ON position.
    6.4. Check for fuel leaks.