Removal Procedure
- Hoist the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Disconnect the hoses from the EVAP canister.
- Remove the EVAP canister retainer attaching bolt.
- Remove the EVAP canister and retainer.
- Remove the EVAP canister retainer from the canister.
Caution: To avoid any vehicle damage, serious personal injury or death when major components are removed from the vehicle and the vehicle is supported by a hoist, support the vehicle with jack stands at the opposite end from which the components are being removed and strap the vehicle to the hoist.
Notice: The EVAP canister may have released carbon particles which caused this part to fail and may cause damage to other components. Check the EVAP canister for loose carbon before returning the vehicle to service.
Installation Procedure
- Snap the EVAP canister retainer onto the EVAP canister.
- Install the end of the EVAP canister into the tab on the body.
- Install the EVAP canister retainer attaching bolt.
- Connect the hoses to the EVAP canister.
- Lower the vehicle.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
EVAP canister retainer attaching bolt to 10 N·m (88 lb in).
