LOOSE WINDSHIELD GARNISH MOLDING (ADD RETAINER CUP). Oldsmobile Cutlass Ciera 1994

SUBJECT: LOOSE WINDSHIELD GARNISH MOLDING (ADD RETAINER CLIP)

MODELS: 1994-95 BUICK CENTURY 1994-95 OLDSMOBILE CUTLASS CIERA

CONDITION:

SOME OWNERS MAY COMMENT THAT THE WINDSHIELD GARNISH MOLDINGS ARE LOOSE FROM THE "A" PILLAR.

CORRECTION:

INSTALL ADDITIONAL RETAINER CLIP, FOLLOWING PROCEDURE BELOW:

1. REMOVE MOLDING FROM THE VEHICLE FOLLOWING THE PROCEDURE LISTED IN THE SHOP MANUAL, SECTION 10-9.

2. REINSTALL THE PLASTIC RETAINERS INTO THE SLOTS IN THE RETAINER HOUSING OF THE MOLDING.

3. INSERT AND FULLY SEAT RETAINER, P/N 12338108, AS SHOWN IN FIGURE 1. THIS RETAINER WILL CLOSE OFF THE END SLOT IN THE RETAINER HOUSING AND PREVENT THE PLASTIC RETAINER FROM SLIDING OUT.

4. REINSTALL MOLDING TO WINDSHIELD PILLAR AND ALONG ROOF TO LOCK PILLAR.

PART AVAILABILITY:

PARTS ARE CURRENTLY AVAILABLE FROM GMSPO.

WARRANTY INFORMATION:

FOR VEHICLES REPAIRED UNDER WARRANTY, USE: LABOR OPERATION: C2000 RIGHT SIDE, C2001 LEFT SIDE LABOR TIME: 0.2 HR.

FIGURES: 1

Object Number: 84871 Size: FS

GENERAL MOTORS BULLETINS ARE INTENDED FOR USE BY PROFESSIONAL TECHNICIANS, NOT A "DO-IT-YOURSELFER". THEY ARE WRITTEN TO INFORM THOSE TECHNICIANS OF CONDITIONS THAT MAY OCCUR ON SOME VEHICLES, OR TO PROVIDE INFORMATION THAT COULD ASSIST IN THE PROPER SERVICE OF A VEHICLE. PROPERLY TRAINED TECHNICIANS HAVE THE EQUIPMENT, TOOLS, SAFETY INSTRUCTIONS AND KNOW-HOW TO DO A JOB PROPERLY AND SAFELY. IF A CONDITION IS DESCRIBED, DO NOT ASSUME THAT THE BULLETIN APPLIES TO YOUR VEHICLE, OR THAT YOUR VEHICLE WILL HAVE THAT CONDITION. SEE A GENERAL MOTORS DEALER SERVICING YOUR BRAND OF GENERAL MOTORS VEHICLE FOR INFORMATION ON WHETHER YOUR VEHICLE MAY BENEFIT FROM THE INFORMATION.