FRONT STABILIZER BAR BUSHING SQUAWK NOISE. Oldsmobile Cutlass Supreme 1989

THIS BULLTIN HAS BEEN REVISED TO DESIGNATE THE VIN BREAKPOINTS FOR CHEVROLET ONLY.

CONDITION: SOME 1988-90 W-CARS ASSEMBLED PRIOR TO VIN BREAKPOINTS INDICATED BELOW MAY EXHIBIT A SQUAWKING NOISE FROM THE FRONT OF THE VEHICLE AT LOW AMBIENT TEMPERATURES AND NORMAL VEHICLE OPERATION.

CHEVROLET - (OSHAWA #1) L9279163 (OSHAWA #2) L1201451 OLDSMOBILE - 395552 PONTIAC - 296738 BUICK - 407852

CAUSE: MAY BE CAUSED BY THE FRONT STABILIZER BAR ROTATING IN THE LOWER CONTROL ARM STABILIZER BAR INSULATORS.

CORRECTION: REPLACE EXISTING LOWER CONTROL ARM STABILIZER BAR INSULATORS WITH NEW HIGH COMPRESSION INSULATORS P/N 10152155 (2 REQUIRED) FOLLOWING APPLICABLE SHOP MANUAL PROCEDURE.

PARTS ARE CURRENTLY AVAILABLE FROM GMSPO.

LABOR OPERATION NUMBER: E2147

LABOR TIME : .8 HOURS

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.