Air Cleaner Element Replacement for Oldsmobile Eighty Eight 1999

1. Remove the IAT sensor connector (1) from the IAT sensor (2).
2. Remove the rear air cleaner intake duct from the Mass Air Flow Sensor (MAF) end of the duct. Refer to Air Cleaner Inlet Duct Replacement .



3. Remove the screws securing the front air cleaner intake duct to the air cleaner housing.
4. Remove the air filter element.
5. Inspect the air filter element for dust, dirt, water and replace if required.

1. Install the air filter element.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the two screws securing the front air intake duct to the air cleaner housing.

Tighten
Tighten the screws to 2 N·m (18 lb in).




3. Install the air cleaner intake duct. Refer to Air Cleaner Inlet Duct Replacement .

Tighten
Tighten the clamp to 2 N·m (18 lb in).

4. Install the IAT sensor connector (1) from the IAT sensor (2).