GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Oldsmobile 🢒 1999 🢒 Intrigue 🢒 Engine 🢒 Engine Mechanical - 3.5L 🢒 Ignition Coil Module Installation

Ignition Coil Module Installation Left


    Object Number: 326350 Size: SH
  1. Press the spark plug boots onto the ignition coil assembly.

    2. Object Number: 1708818 Size: SH
  2. Apply a small amount of dielectric grease GM P/N 12345579, (Canadian P/N 1974984), to each spark plug boot (1) of the ignition coil assembly.

    3. Object Number: 235245 Size: SH
  3. Lower the ignition coil assembly into the camshaft cover valley. DO NOT damage the ignition coil assembly's perimeter seal.

    4. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  4. Install the ignition coil assembly bolts.

    5. Tighten
    Tighten the ignition coil assembly bolts to 9 N·m (80 lb in).

Ignition Coil Module Installation Right


    Object Number: 326350 Size: SH
  1. Press the spark plug boots onto the ignition coil assembly.

    2. Object Number: 1708818 Size: SH
  2. Apply a small amount of dielectric grease GM P/N 12345579, (Canadian P/N 1974984), to each spark plug boot (1) of the ignition coil assembly.

    3. Object Number: 483168 Size: SH
  3. Lower the ignition coil assembly into the camshaft cover valley. DO NOT damage the ignition coil assembly's perimeter seal.

    4. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  4. Install the ignition coil assembly bolts.

    5. Tighten
    Tighten the ignition coil assembly bolts to 9 N·m (80 lb in).


    Object Number: 483053 Size: SH
  5. Install the fuel injector sight shield bracket.
  6. Install the fuel injector sight shield bracket bolts.

    7. Tighten
    Tighten the fuel injector sight shield bracket bolts to 8 N·m (71 lb in).