1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement in Engine Mechanical.



2. Rotate the throttle lever.
3. Disconnect the cruise control cable (1) from the bracket (2).



4. Disconnect the accelerator cable (2) from the bracket (1).



5. Remove the wiring harness clip (1) from bracket (3).



6. Remove the 2 bolts from the bracket.

Notice: Do not route flexible components (hoses, wires, conduits, etc.) within 50 mm (2 in) of moving parts unless flexible components can be securely fastened. This is necessary in order to prevent possible interference and damage to the component.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

1. Install the 2 brackets bolts.

Tighten
Tighten the bolts to 16 N·m (142 lb in)




2. Connect wiring harness clip (1) to the bracket (3).



3. Connect the accelerator cable (2) to the bracket (1).



4. Connect the cruise control cable (1) to the bracket (2).




Important: The throttle should operate freely, without binding, between full closed and wide open throttle.

5. Test for complete throttle opening and closing by operating the accelerator pedal. Also inspect for proper carpet fit under the accelerator pedal.
6. Reinstall the fuel injection sight shield. Refer to Fuel Injector Sight Shield Replacement in Engine Mechanical.