Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

Caution: Refer to Lifting and Jacking the Vehicle in the Preface section.

Important: Inspect the canister hoses for damage or deterioration. Refer to the Emission Hose Routing Diagram for proper routing of the canister hoses. When replacing the lines, use the correct replacement part.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

Reinstall the driver side housing liner and the wheel assembly.

Tighten
Tighten the wheel nuts to 140 N·m (104 lb ft).